Question: Should WIRE be up or down to make ice?

NOTE: Your ice maker has an automatic shutoff. As ice is made, the ice cubes will fill the ice storage bin and the ice cubes will raise the wire shutoff arm to the OFF (arm up) position. Do not force the wire shutoff arm up or down.

Why is my ice maker not making ice?

If your ice maker isnt producing ice at all or is producing crescents or cubes that are smaller than usual, its typically indicative of a clog somewhere along the supply line. Cause: A common cause for a clog is frozen water in the line. Fix: To repair a frozen line, slide the refrigerator and unplug it.

How do I set up my ice maker?

Turn the small adjustment set screw on the upper, middle right hand side of your ice maker a half of a turn with a Phillips or flat head screwdriver, depending on the screw your ice maker has. Turning the screw clockwise will decrease the water level and turning it counterclockwise will increase the water level.

How do you use an ice maker in a freezer?

0:231:28How To Make Ice Cubes In Refrigerator Ice Maker With YouTubeStart of suggested clipEnd of suggested clipAnd pour the water into the tray. Its kind of pour in and slowly go too fast itll subtly go to theMoreAnd pour the water into the tray. Its kind of pour in and slowly go too fast itll subtly go to the bottom tray. Yeah. So just fill up like that.

How do I adjust the water on my ice maker?

1:202:43Ice Maker Troubleshooting and Adjusting - Cube Size - YouTubeYouTube

How do I know my ice maker is working?

To check if the icemaker itself is working:If the icemaker mold is empty, you can manually pour about 4 ounces of water in the icemaker mold.Wait about 2 hours.If the icemaker has dropped ice cubes out from the mold, you know the icemaker itself is working.

Does ice maker need drain?

In order for the water to drain you need either a gravity drain or a pump. The pump simply pumps the water from your ice maker to the sink drain. If you have a crescent ice maker, you dont need a drain since these ice cubes create cold like a freezer and do not melt until removed.

How do you manually cycle a whirlpool ice maker?

Look at the center of the Whirlpool icemaker to find the rotating arm that pushes the ice cubes out. Grab the plastic teeth on the arm, and gently pull them in a clockwise direction. You will hear a slight winding sound. The icemaker should start into its cycle.

Contact us

Find us at the office

Kanarek- Prusa street no. 1, 91754 Niamey, Niger

Give us a ring

Saivon Onweller
+48 362 334 509
Mon - Fri, 7:00-18:00

Tell us about you