Question: Where is my remote start module?

This is required by the remote starter so that it disengages the starter once the car has started. It can usually be found in the engine distributor or coil pack.

Where is the remote start module located?

The control module will be a black box typically mounted under the drivers side dashboard near the steering column, approximately the the size of a mans wallet (3x4) with wires coming out of the side.

What is a remote start module?

Simply, a remote starter mimics your presence in the vehicle to make it start. In some vehicles, the process involves unlocking the doors as well as turning the ignition key or pressing the start button.

How do I know if my car has a remote starter?

Ultimately, to tell if a car offers a remote start feature, youll want to look at two main things: the key fob and the owners manual. If your vehicle offers remote start then there will be a special button on the key fob. Often the remote start button on a key fob is an arrow pointing in a circle.

How do you program a remote starter?

0:171:45Programming Compustar Remotes (Traditional Key Vehicles) - YouTubeYouTube

How do I know if I need a bypass module for remote start?

If your vehicle was manufactured after the year 2000 and your key has a transponder, then YES you do need a bypass module for remote start. If youre not sure if your vehicle falls into this category (and it likely does) dons worry, your installer will be able to advise you.

What is the use of remote start?

A remote start gives your vehicle extra time to reach normal operating temperature, warming the engine and making the oil less viscous, allowing it to flow freely through the engine. Although there is no doubt a remote start will make your drive warm and comfortable, the accessory is not for everyone.

How does a remote engine starter work?

In short, remote starters simulate the engine starting sequence you initiate when you turn on the car with your key. However, a remote car starter does this without a physical key in the ignition. This is made possible when the control module is wired into your ignition switch and other starter mechanisms.

How do I resync my remote starter?

Press the Lock button on your remote car starter. Within five seconds of turning it on, turn your key back to the off position (or press the start button again). Repeat the on-off cycle three more times—youll do four in total.

What is the valet button on a remote start?

Valet mode is a setting in Compustar and Arctic Start systems that will shut down the alarm system and the remote starter. It will only allow the remotes to retain key-less entry to be used to lock and unlock the doors.

How do I program my remote start silencer?

Programming Instructions:Turn the Ignition switch OFF/ON 3 TIMES and stay in ON position. Push the Valet switch 3 times and hold in on the 3rd push, when a long chirp is heard then release the valet switch. Press any button on transmitter 1 until the siren responds with a confirming chirp; the first transmitter is.More items

How do you use automate remote start?

When the engine is OFF, press and hold the remote control button for three seconds. The parking lights flash slowly several times allowing you to locate your vehicle. This feature allows you to remotely start and run your vehicle for a programmable period of time.

How do you bypass a transponder?

2:173:50How to Bypass The Key Chip Transponder In Any Car Or TruckYouTube

How do you bypass a keyless ignition?

0:000:38How To Override The Push Button Start - YouTubeYouTube

Contact us

Find us at the office

Kanarek- Prusa street no. 1, 91754 Niamey, Niger

Give us a ring

Saivon Onweller
+48 362 334 509
Mon - Fri, 7:00-18:00

Tell us about you